Hey ive jst got a new gumshield but when i put it in, it makes me almost throw up, is it possible to trim them at the back?
Was gonna cut it down with scissors, but might aswell find out if it will fuck up first..
Gum Shield
Hey ive jst got a new gumshield but when i put it in, it makes me almost throw up, is it possible to trim them at the back?
Was gonna cut it down with scissors, but might aswell find out if it will fuck up first..
is this one made by the dentist ?
Nope lol.
Just orderd it online, i havent moulded it yet, but its clearly gonna make me sick,it goes to far back,.so i might try ' trim it
www.opro.co.uk
the business when it comes to gumshields.
Just mould it first then trim off any excess with scissors mate.
Yeah, you shouldn't have any problem trimming bits off unless you end up trimming too much.
THe best fitting gum shield I ever had. I'd only ever use boil and bite again as a stop gap measure until I could get a custom oneOriginally Posted by Yak
Any opinions I express on this forum are entirely personal opinions and it should not be assumed that they reflect the official view of any organisations I am connected with
Also proud sponsors of Jason Young
Opro are dicks; I wanted a swastika on my gumshield.
Would they do it?, would they fuck.
I am, ofcourse, joking.
Opro are very good, my only gripe is that I got a tribal printed shield a few months back and the designs a bit crooked; but the shield itself fits like a glove. For your teeth.
I don't seem to remember it taking too long to arrive after I sent back the imprint either.
Posting Permissions
Reply With Quote